Operation Manual

Problem Action
The scan driver has not been registered
on your computer and cannot be
accessed from Express Scan Manager.
Install the scan driver. If the scan driver is installed, uninstalled it and then re-install
it. After the installation of the scan driver is completed, re-install the Express Scan
Manager.
Failed to scan your document on the
printer via Express Scan Manager.
Ensure that your computer and the printer is properly connected with the USB
cable.
Check whether the printer is on. If the printer is on, reboot it by turning the power
switch off and then on again.
If a scan application is running, close the application once, restart the application,
and then try scanning again.
Network connection cannot be used. Connect with the USB cable.
Uninstall Express Scan Manager on your computer and then re-install it.
Failed to create an image file via
Express Scan Manager.
Ensure there is sufficient space in your hard disk.
Uninstall Express Scan Manager on your computer and then re-install it.
Failed to initialize Express Scan
Manager.
Uninstall Express Scan Manager on your computer and then re-install it.
Failed to execute Express Scan
Manager.
Uninstall Express Scan Manager on your computer and then re-install it.
An unexpected error occurred on
Express Scan Manager.
Uninstall Express Scan Manager on your computer and then re-install it.
Other Problems
Problem Action
Condensation has occurred inside the
printer.
This usually occurs within several hours after you heat the room in winter. This also
occurs when the printer is operating in a location where relative humidity reaches
85% or more. Adjust the humidity or relocate the printer to an appropriate
environment.
"092-310", “092-910", or “092-410" is
displayed.
Clean the CTD sensor.
See Also:
“Cleaning the Color Toner Density (CTD) Sensor” on page 394
Epson AcuLaser CX29 Series User’s Guide
Troubleshooting 365