Operation Manual

5. Select Panel Lock Set, and then press the button.
6. Select Enable, and then press the
button.
7. Enter the new password, and then press the
button.
8. Re-enter the password to confirm the password that you entered, and then press the
button.
Note:
❏ The factory-default panel password is 0000.
❏ Be sure to remember the password. The procedure described below allows you to reset the password,
but the settings for Address Book and Phone Book are cleared.
❏ Turn off the printer. Then, while holding the System button, turn on the printer.
❏ If you change the password while Panel Lock Set is Enable, perform steps 1 to 2. Enter the
current password, and then press the
button. Perform steps 3 to 4. Select Change Password,
and then press the
button. Enter the current password, and then press the button. Perform
steps 7 and 8. This will change the password.
Disabling the Panel Lock
1. Press the System button.
2. Select Admin Menu, and then press the
button.
3. Enter the password, and then press the
button.
4. Select Secure Settings, and then press the
button.
5. Select Panel Lock, and then press the
button.
6. Select Panel Lock Set, and then press the
button.
7. Select Disable, and then press the
button.
8. Enter the current password, and then press the
button.
Epson AcuLaser CX29 Series User’s Guide
Using the Operator Panel Menus and Keypad 299