Operation Manual

Adobe Protocol
Purpose:
To set the PostScript communications protocol.
Values:
Auto
Sets the PostScript communications protocol automatically.
Standard
Sets the PostScript communications protocol to Standard.
BCP
Sets the PostScript communications protocol to BCP.
TBCP*
Sets the PostScript communications protocol to TBCP.
Binary
Sets the PostScript communications protocol to Binary.
System Settings
Use System Settings to configure a variety of printer features.
Note:
Values marked by an asterisk (*) are the factory default menu settings.
Power Saver Timer
Purpose:
To specify the time for transition to power saver mode.
Values:
Low Power
Timer
3min*
Specifies the time taken by the printer to enter Low Power mode after it finishes
a job.
3–60 min.
Sleep Timer 6min*
Specifies the time taken by the printer to enter Sleep mode after it has entered
Low Power mode.
1–6 min.
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less
energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical
circuit with room lighting and you notice lights flickering.
Epson AcuLaser CX29 Series User’s Guide
Using the Operator Panel Menus and Keypad 253