Operation Manual

Adobe Protocol
Purpose:
To set the PostScript communications protocol.
Values:
Auto*
Sets the PostScript communications protocol automatically.
Standard
Sets the PostScript communications protocol to Standard.
BCP
Sets the PostScript communications protocol to BCP.
TBCP
Sets the PostScript communications protocol to TBCP.
Binary
Sets the PostScript communications protocol to Binary.
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
Note:
Values marked by an asterisk (*) are the factory default menu settings.
Ans Select
Purpose:
To select the default fax receiving mode.
Values:
TEL Mode
Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external phone and then pressing the remote receive code, or
by setting OnHook to On (you can hear voice or fax tones from the remote
machine) and then pressing Start button.
FAX Mode*
Automatically receives faxes.
TEL/FAX Mode
When the printer receives an incoming fax, the external telephone rings for the
time specified in Auto Ans. Tel/Fax, and then the printer automatically
receives a fax. If an incoming call is not a fax, the printer beeps from the internal
speaker indicating that the call is a telephone call.
Ans/FAX Mode
The printer can share a telephone line with an answering machine. In this
mode, the printer will monitor the fax signal and pick up the line if there are fax
tones. If the phone communication in your region is serial, this mode is not
supported.
Epson AcuLaser CX29 Series User’s Guide
Using the Operator Panel Menus and Keypad 243