Operation Manual

Purpose:
To block data received from certain IP addresses through the wired network. You can set up to five IP
addresses. The change becomes effective after the printer is turned off and then on again.
Values:
No. n / Address (n is 1–5.)
Sets the IP address for Filter n.
No. n / Mask (n is 1–5.)
Sets the address mask for Filter n.
No. n / Mode (n is 1–
5.)
Off*
Disables the IP Filter feature for Filter n.
Accept
Accepts an access from the specified IP address.
Reject
Rejects an access from the specified IP address.
IEEE 802.1x
Note:
❏ IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is
available only when the IEEE 802.1 authentication is enabled.
❏ To enable IEEE 802.1x, use “EpsonNet Config” on page 52. For details, refer to the Help on the
Software Disc.
Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off
and then on again.
Value:
Disable
Disables IEEE 802.1x.
Initialize NVM
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function
and rebooting the printer, all wired network settings are reset to their default values.
Values:
Yes
Initializes the wired network data stored in NVM.
No*
Does not initialize the wired network data stored in NVM.
Epson AcuLaser CX29 Series User’s Guide
Using the Operator Panel Menus and Keypad 242