Operation Manual

See Also:
❏ “Loading an Original Document on the ADF” on page 194
❏ “Loading an Original Document on the Document Glass” on page 195
2. Press the Fax button.
3. Adjust the document resolution to suit your fax needs.
See Also:
❏ “Resolution” on page 196
❏ “Lighten/Darken” on page 197
4. Select OnHook, and then press the
button.
5. Select On, and then press the
button.
6. Enter the remote fax machine’s fax number using the numeric keypad.
Note:
❏ You can enter a fax number using the ten key, *, and #.
❏ Pressing the Redial/Pause button enables you to enter a pause in the fax number.
❏ Entering “=” in the fax number enables dial tone detection.
❏ Entering “:” enables you to switch dialing type from dial pulse (DP) to push button (PB).
7. If the document is loaded in the ADF, press the Start button.
If the document is not loaded in the ADF, press the Start button, press the
or button until the
desired setting appears, and then press the
button.
Note:
By pressing the Stop button, you can cancel the fax job at any time while sending the fax.
Confirming Transmissions
When the last page of your document has been sent successfully, the printer beeps and returns to the
standby mode.
Epson AcuLaser CX29 Series User’s Guide
Faxing 200