User`s guide

Status, Error, and Service Messages256
COMMUNICATION ERROR
USB Memory
While data was
being sent in Scan
mode, the connec-
tion to the USB
memory device was
interrupted.
Check the connection
to the USB memory
device, and then try
sending the data
again.
COMMUNICATION ERROR
xxx Server
While data was
being sent in Scan
mode, the connec-
tion to the server
was interrupted.
Check the settings in
the NETWORK SET-
TING menu, and then
try sending the data
again.
DISCONNECT
USB Memory
The connection to
the USB memory
device was inter-
rupted.
Check the connection
to the USB memory
device, and then try
sending the scan
again.
DISCONNECT
xxx Server
The connection to
the server was inter-
rupted.
Check the settings in
the NETWORK SET-
TING menu, and then
try connecting again.
Fuser Unit Life
The time to replace
the fuser unit has
been reached.
Replace the fuser unit.
Contact a qualified ser-
vice representative.
HOLD JOB ERROR
UNABLE TO STORE JOB
The hard disk drive
is not installed on
the machine so a
job to be stored
could not be
received.
To store jobs, install
the optional hard disk
drive on the machine.
HOLD JOB ERROR
MEMORY FULL
Since the memory is
full, stored jobs can-
not be printed.
Create free space on
the memory, and then
try printing the stored
jobs again.
HOLD JOB ERROR
NO TRAY3
Since Tray 3 is not
installed, stored
jobs cannot be
printed.
To print the jobs, install
Tray 3, and then try
printing the stored jobs
again.
This message... means... Do this...
Downloaded from ManualsPrinter.com Manuals