User`s guide

Copying Problems 327
❏ The accuracy of the copy depends on the quality and size of the original. Try adjusting
the contrast with the product. If your original is too light, the copy might not be able to
compensate, even if you adjust the contrast.
❏ If the original have a colored background, images in the foreground might blend too
much or the background might appear in a different shade. Adjust the settings before
copying or enhance the image after it has been copied.
Improving copy quality
Try one or more of the following solutions.
❏ Copy from the document table. This will produce a higher quality copy than copying
from the Auto Document Feeder.
❏ Use quality originals.
❏ Load the media correctly. If the media is loaded incorrectly, it might skew, causing
unclear images and problems with the OCR application.
❏ Open or close the MP tray to accommodate the copy job. If you are copying to standard
weight media, use the paper cassette. If you are copying to heavy media, use the MP
tray.
❏ If your product frequently feeds more than one page at a time, replace the pickup roller.
❏ Use or make a carrier sheet to protect your originals.
Completely blank pages are output
Try one or more of the following solutions.
❏ The original might have been loaded upside down. In the Auto Document Feeder, load
the original with the short edge forward and the side to be scanned facing up.
❏ If you are getting blank pages when scanning from the document table, make sure the
original is loaded correctly. Place the original face-down on the document table with the
top left corner of the document located in the lower right corner of the glass.
❏ The media might not meet EPSON’s media specifications (e.g., the media is too moist
or too rough).
❏ The toner might be out.
❏ The tape might not have been removed from the toner cartridge.
Downloaded from ManualsPrinter.com Manuals