User`s guide

Scanning Problems 322
Printed colors are different from those in the original image.
Exact color matching is very difficult. Check your software or contact the manufacturer of
your product for information on color matching and calibration.
ADF Scanning Problems
A blank copy is output even though an original is set on the Auto
Document Feeder during scanning.
Check if the ADF unit or ADF cover is closed firmly.
You cannot scan using the Auto Document Feeder.
Try one or more of the following solutions:
❏ Make sure either the Office Mode or the Professional Mode is selected in EPSON Scan.
❏ Make sure ADF-Single-sided or ADF-Double-sided is selected as the document
source in EPSON Scan.
❏ If the Auto Document Feeder is open, close it and then try again. If the Auto Document
Feeder is already open while you are scanning, remove any jammed paper; reload any
document not yet scanned and then restart EPSON Scan.
❏ Remove any jammed paper, and then reload the document and restart EPSON Scan.
❏ Check if the ADF pickup roller is dirty. If the pickup roller is not clean, wipe it with a wet,
well-wrung cloth. For details, see "Cleaning the ADF pickup roller" on page 291.
A line of dots always appears in your scanned image.
The exposure table for Auto Document Feeder may be dusty or scratched. Clean the table.
See "Cleaning the document table and the exposure window for Auto Document Feeder"
on page 291 for details. If you still have the problem, contact your dealer.
Downloaded from ManualsPrinter.com Manuals