User`s guide

Using the Control Panel 262
The paper loaded in the specified paper source (tttt) does not match the required paper
size (sssss). Replace the loaded paper with the correct size paper and press the x B&W
Start or x Color Start button to resume printing, or press the y Cancel button to cancel the
print job.
If you press the x B&W Start or x Color Start button without replacing the paper, the
product will print on the loaded paper even though it does not match the required size.
Photoconductor Trouble
A read/write error has occurred for the photoconductor unit. Remove the photoconductor
unit and reinsert it. If that fails to clear the error, replace the photoconductor unit. To install
the photoconductor unit. See "Photoconductor Unit" on page 281.
Please Wait
The toner cartridge to be replaced is moving to the replacement position in the product.
Print Overrun
The required time to process the print data exceeded the print engine speed because the
current page is too complex. Press the x B&W Start or x Color Start button to resume
printing, or press the y Cancel button to cancel the print job. If this message appears
again, select Avoid Page Error on the printer driver.
If you continue to receive this message when printing a particular page, try simplifying the
page by limiting the number of graphics or reducing the number and size of fonts.
You can also add more memory to the product as described in "Memory Module" on page
273.
RAM CHECK
The product is checking the RAM.
Ready
The product is ready to receive data and print.
Remove Photoconductor
When setting up the product, the photoconductor unit was installed before all toner
cartridges were installed.
Open cover B, remove the photoconductor unit, then close cover B.
Replace Photoconductor
Downloaded from ManualsPrinter.com Manuals