User`s guide

Using the Control Panel 251
USB Menu
These settings control communication between the product and the computer when using
a USB interface.
*1
After this item is changed, the setting value takes effect after a warm boot or after the power is turned on
again. While it is reflected in the Status Sheet, the actual change takes effect after a warm boot or after the
power is turned on again.
*2
Displayed only when a USB external device is connected and the USB Ext I/F Confg is set to Yes. The
contents of the settings depend on the USB external device settings.
*3
This setting cannot be changed only when the Get IPAddress is set to Auto.
*4
When the Get IPAddress is changed from Panel or PING to Auto, the panel setting values are saved. When
Auto is changed to Panel or PING, the saved setting values are displayed. 192.168.192.168 if the settings
are not made from the panel.
USB I/F
Allows you to activate or deactivate the USB interface.
USB Speed
Allows you to select the operation mode of USB interface. Selecting HS is recommended.
Select FS if HS does not work on your computer system.
Buffer Size
Item Settings
USB I/F
*1
On, Off
USB Speed
*1
HS, FS
USB ExtI/FConfg
*1
Yes, No
Get IPAddress
*2
Panel, Auto, PING
IP (IP address)
*2*3*4
0.0.0.0 to 255.255.255.255
SM (Subnet mask)
*2
0.0.0.0 to 255.255.255.255
GW (Gateway address)
*2
0.0.0.0 to 255.255.255.255
AppleTalk
*2
On, Off
MS Network
*2
On, Off
Bonjour
*2
On, Off
USB EXT I/F Init
*2
-
Buffer Size Normal, Maximum, Minimum
Downloaded from ManualsPrinter.com Manuals