User`s guide

Copying 202
1. Make sure that the product is in Copy mode. If not, press the Copy button to enter
the Copy mode.
2. Press the u Up or d Down button several times until Contrast is selected.
The current value next to Contrast is highlighted.
3. Specify the contrast level.
Note:
To increase or decrease the contrast, press the r Right or l Left button, respectively. The
contrast increases or decreases one level at a time.
Adjusting the RGB color
You can adjust the image quality in RGB strength by selecting from 7 levels (-3 to 3) for red
(R), green (G), and blue (B). The higher the level, the richer the image. The default level is
0. For adjusting the image quality, see also "Adjusting the density" on page 201 and
"Adjusting the contrast" on page 201.
Note:
RGB adjustment is available only for color copies.
1. Make sure that the product is in Copy mode. If not, press the Copy button to enter
the Copy mode.
2. Press the u Up or d Down button several times until your desired color (R, G, or B) is
selected.
The current value next to R, G, or B is highlighted.
3. Specify the color strength.
Note:
To increase or decrease the color strength, press the r Right or l Left button, respectively. The
color density increases or decreases one level at a time.
Specifying the zoom ratio
You can specify a zoom ratio by selecting from the fixed zoom ratios, or by specifying a
value from 25 to 400% in increments of 1%. The default zoom ratio is 100%.
1. Make sure that the product is in Copy mode. If not, press the Copy button to enter
the Copy mode.
Downloaded from ManualsPrinter.com Manuals