Setup guide

306 Troubleshooting
Manual Feed sss
The manual feed mode is specified for the current print job. Make
sure the paper size indicated by sss is loaded, then press the N
Start/Stop button.
Mem Overflow
The printer has insufficient memory to execute the current task.
Press the N
Start/Stop button on the control panel to resume
printing, or press the + Cancel Job button to cancel the print job.
Menus Locked
This message appears if you try to change the printer’s settings
through the control panel when the buttons are locked. You can
unlock them by using the Network utility. Refer to the Network
Guide for information.
Need Memory
The printer has insufficient memory to complete the current print
job.
To clear this error message, select Clear Warning from the control
panel’s Reset Menu. See “How to access the control panel menus”
on page 338 for instructions.
To prevent this problem from happening again, add more
memory to your printer as described in “Memory modules” on
page 334, or reduce the resolution of the image to be printed.