Setup guide

264 Maintenance and Transportation
Handling precautions
Note the following handling precautions before replacing the
photoconductor unit:
❏ The photoconductor unit weighs 4.5 kg (9.9 lb). Be sure to hold
it firmly by the handle when carrying it.
❏ When replacing the photoconductor unit, avoid exposing it
to room light any longer than necessary.
❏ Be careful not to scratch the surface of the drum. Also, avoid
touching the drum, since oil from your skin may permanently
damage its surface and affect print quality.
❏ To get the best print quality, do not store the photoconductor
unit in an area subject to direct sunlight, dust, salty air, or
corrosive gases (such as ammonia). Avoid locations subject to
extreme or rapid changes in temperature or humidity.
❏ Do not tilt the photoconductor unit.
w
Warning:
❏ Do not dispose of the used photoconductor unit in fire, as it
may explode and cause injury. Dispose of it according to local
regulations.
❏ Keep the photoconductor unit out of the reach of children.
Replacing the photoconductor unit
Follow these steps to replace the photoconductor unit.
1. Turn off the printer.