User`s guide

The cursor moves to the next octet.
18. Repeat steps 16 to 17 to set subnet mask, and then press the
button.
19. Ensure that the message Restart Printer to apply setting appears, and then press any
button.
20. Press the
button to select Gateway Address, and then press the button.
The cursor is located at the first octet of the gateway address.
21. Specify the value of the gateway address using the
or button.
22. Press the
button.
The cursor moves to the next octet.
23. Repeat steps 21 to 22 to set gateway address, and then press the
button.
24. Ensure that the message Restart Printer to apply setting appears, and then press any
button.
25. Turn off and turn on the printer.
See Also:
“Operator Panel” on page 18
Verifying the IP Settings
You can confirm the settings by printing the system settings report or using the ping command.
The following procedure uses Windows XP as an example.
1. Print the Printer Settings page.
2. Look under the IPv4 heading on the Printer Settings page to ensure that the IP address, subnet
mask, and gateway are appropriate.
To verify if the printer is active on the network, run the ping command in your computer:
1. Click start, and select Run.
Epson AcuLaser C2900 Series User’s Guide
Network Basics 45
Downloaded from ManualsPrinter.com Manuals