User`s guide

8. Enter an Administrator name and password, and click [OK].
9. When a message appears telling you installation has completed, click [Close].
This completes the installation.
When using Mac OS X 10.4, proceed to “Adding a Printer (Mac OS X 10.4)” on page 23.
When using Mac OS X 10.5-10.6, proceed to “Adding a Printer (Mac OS X 10.5-10.6)” on
page 26.
Adding a Printer (Mac OS X 10.4)
After the PPD file has been installed, set the PPD file for the print driver, and then add the printer.
The print driver controls the printer functions based on the information in the PPD file.
As an example, this section describes how to add a printer in a Mac OS X 10.4.
1. Start Macintosh.
2. Check that the printer port is set to Enable.
❏ When using IP Printing
Set the LPD port to Enable.
Note:
Printers on an IP network can be detected automatically. To enable the discovery function, start
[Bonjour].
❏ When using [USB-1(2.0)] / [USB-2(2.0)]
Epson AcuLaser CX29/C2900 Series PostScript User’s Guide
Installing of Print Drivers for Macintosh Computers 23