Setup guide

4
Safety Instructions
❏ If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and over-
current protection for this printer, the building installation
must be protected by 10 or 16 amp circuit breaker.
Safety Information
Laser safety labels
w
Warning:
The use of controls, or the performance of procedures and
adjustments other than those specified in this guide may result
in hazardous radiation exposure.
Internal laser radiation
Max. Radiation Power 1.16 m
W
Wave Length
775 to 795 nm
Your printer is a Class 1 laser product
as defined in the IEC60825
specifications. The label shown below
is attached in countries where
required.
This is a Class IIIb Laser Diode Assembly
that has an invisible laser beam. The
printer head unit is NOT A SERVICE ITEM,
Therefore, the printer head unit should
not be opened under any
circumstances. An additional laser
warning label is affixed to the inside of the
printer.