User`s guide

Multi-part forms

You can use the built-in tractor to print on carbonless

multi-part forms of up to four parts (one original plus three

copies). Before you print on the forms, set the paper-thickness

lever as described in the previous section. These tips will help

you get good results:

❏

Load multi-part forms with the tractor only, not in the

cut-sheet feeder or paper guide. For instructions, see

“ Printing on Continuous Paper” on page 2-7.

❏

Use only multi-part forms that are free of wrinkles and

waves. Never load multi-part forms joined by metal

staples, tape, or continuous gluing.

❏

If you need to adjust the loading position, use your

software program or change the loading position as

described on page 2-5.

❏

When you use multi-part forms, raise the paper guide as

shown.

Note

If you print on multi-part forms without raising the paper guide,

the paper may jam.

2-16a

ILLO?

Blackberry REV.D

A5 size Chapter 2

96/04/08 pass 1

Using the Printer

2-19