User`s guide

Printing in the pull tractor position
To load continuous paper using the pull tractor, you must
move the tractor to the pull tractor position, as described in
steps 1 through 3 below. If your tractor is already installed in
this position, make sure the printer is off and skip to step 5.
c
Caution:
❏
Use the knob on the right side of the printer only to clear
paper jams and only when the printer is off. Otherwise,
you may damage the printer or change the top-of-form
position.
❏
When using the pull tractor, set the auto tear off feature in
the Printer Setting mode to off; otherwise the paper may
jam.
1. Turn the printer off; then remove the paper guide. Pull the
paper-release lever forward to the continuous paper
position as shown in the illustration on page 2-8.
2. Squeeze the tractor’s lock tabs gently and pull the tractor
away from the printer. Remove the printer cover.
2-10
R
Blackberry REV.D
A5 size Chapter 2
96/04/08 pass 1
Using the Printer
2-13