User`s guide

7. Make sure the printer cover is closed. Then turn on the

printer. When the printer receives data, it begins printing

automatically.

8. When you finish printing (the printer receives no data for

three seconds) the printer feeds the perforation of the

continuous paper to the edge of the printer cover so that

you can tear off the last sheet. The

Pause

light flashes.

Note:

❏

Set the auto tear off feature in the Printer Setting mode to on.

Otherwise, the printer does not feed the perforation to the edge of

the printer cover.

❏

If the perforation and the edge of the printer cover do not match,

adjust the paper position by following the steps in “Adjusting the

loading position,” while the

Pause

light is flashing.

When you send more data, the paper automatically feeds back

to the loading position. If you want to change the position

where printing begins on the page, follow the steps on page 2-5

to adjust the loading position.

Switching back to single sheets

To switch to single sheets, press the

Font

and

LF/FF

buttons at

the same time; the printer feeds the paper backward into the

paper-park position. Then follow the steps in “ Loading single

sheets” on page 2-5.

Caution:

Always tear off paper before back-feeding; back-feeding too

many sheets can cause a paper jam.

Blackberry REV.D

A5 size Chapter 2

96/04/08 pass 1

2-12

Using the Printer