User Setup Information

Make sure the printer is turned off and
paper is loaded.
Remove the narrow cover from the
printer.
To enter the default settings
mode, hold down the YES
button while you turn on the
printer.
II
YES
4. The printer prints a series of questions about your printer
settings. Press the YES and NO buttons to respond and make
your changes. All new settings remain in effect until you
change them again.
YES NO
Note:
5. Turn off the printer at any time to exit the default settings mode; then
replace the narrow cover.
You can change the printer settings listed here:
Character table
437, 850,860, 863, 865
Page length*
11“, 12”, 8.5”, 70/6”
Skip over perforation*
On. Off
Tear-off position*
On cutter, Above cutter
TOF position
-3, -2, -1, ±0, +1, +2, +3
Graphic print direction
Unidirectional, Bidirectional
Download
On, Off
Auto line feed
On, Off
Hex dump/Demonstration
Hex dump, Demonstration
* Available only if optional push tractor is installed