Service manual

FCC Compliance Statement

For American Users

This equipment has been tested and found to comply with limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

CAUTION: The connection of a nonshielded equipment interface cable to this equipment

will invalidate the FCC Certification of this device and may cause interference levels that

exceed the limits established by the FCC for this equipment. It is the responsibility of the

user to obtain and use a shielded equipment interface cable with this device. If this

equipment has more than one interface connector, do not leave cables connected to unused

interfaces.

Changes or modifications not expressly approved by Epson America, Inc., could void the user’s

authority to operate this equipment.

For Canadian Users

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital

apparatus as set out in the radio interference regulations of the Canadian Department of

Communications.

Le present appareil numérique n’èmet pas de bruits radioélectrique dépassant les limites

applicables aux appareils numériques de Classe B prescrites dans le règlement sur le brouillage

radioélectriques édicté par le Ministère des Communications du Canada.

LQ-2OO/AP3000

iii