Service manual

Disassembly and Assembly
4.
Remove the belt tension spring from the carriage motor frame. Remove the
0.092 inch (2.3 mm) E-type retaining ring on the carriage motor.
Then remove
the plain washer, belt pulley flange, belt pulley shaft holder, belt pulley, and
timing belt.
Figure 3-26. Removing the Carriage Motor
5.
To remove the carriage motor, move it in the direction indicated by the arrow
in Figure 3-26.
Assembly Notes
Attach the E-rings as follows:
l
When you attach the ring to the left pulley shaft, install it so that its
opening faces left.
l
When you attach the ring to the right pulley shaft, install it so that its
opening faces right.
After you attach the E-rings, use tweezers to check that they are fixed in place
and do not move.
LQ-200/AP3000
3-31