Service manual

Disassembly and Assembly
5. Lift portion A (in Figure 3-21) of the carriage guide shaft ground plate and
remove it frorn the notch in the carriage motor frame. Slide the plate so that
you can remove it from the frame through the plate cutout at B.
Figure 3-21. Removing the Carriage Guide Shaft Ground Plate
6. Turn the printer mechanism right side up. Rotate the left carriage guide
shaft lever fully counterclockwise and pull it out through cutout A. Then turn
the right carriage guide shaft lever fully clockwise and pull it out the same
way.
(Viewed from the Left Side)
Figure 3-22. Removing the Carriage Guide Shaft
LQ-200/AP3000
3-27