Service manual

Disassembly and Assembly
Removing the platen unit and the paper guide
1.
Remove the upper case as described earlier in this chapter.
2.
Remove the ground spring hook under the paper feed motor at the right side
of the platen unit.Then remove the spring from the platen unit.
3.
Turn the shaft holders at the left and right sides of the platen unit as shown
in Figure 3-9. Then lift the platen unit to remove it.
Figure 3-9. Removing the Platen Unit
4.
Disconnect the cable from connector CN9 on the C064 MAIN board.
LQ-2OO/AP3000
3-15