Service manual

Disassembly and Assembly
Removing the transformer
1.
2.
3.
4.
5.
Remove the upper case as described earlier in this chapter.
Disconnect connector CNl on the PEBFIL-II board. (CNl connects the
transformer to the PEBFIL-II board.)
Disconnect connector CNlO on the CO64 MAIN board. (CNlO connects the
transformer to the CO64 MAIN board.)
Remove the CB(0) (M4 x 8) screw that secures the transformer ground
terminal.
Remove the four CBB (M4 x 12) screws and the CB(0) 0!I4 x 8) screw that
secure the transformer. Then remove the transformer.
Figure 3-7. Removing the Transformer
LQ-200/AP3000 3-13