User`s guide

If you set the Disk drive boot sequence option to
C: only, you should disable the Floppy seek option so the
system doesn’t access the diskette drive during the startup
procedure. Disabling this option decreases
the time needed to
start the system.
The other options on this screen determine what you see when
your system starts.
The Display SETUP prompt during POST Option
allows you to disable the message Press <F2> to enter
SETUP that you see during power-on diagnostics. You may
want to disable this prompt to prevent unauthorized users
from seeing the SETUP prompt. Even when the message is
disabled, however, you can still start SETUP by pressing F2
during power-on diagnostics.
The Pause on POST errors option allows you todisable
the error message, followed by the message Press <F1> to
resume, <F2> to Setup that you see when the system
identifies a configuration error. If you disable this option, the
system ignores configuration errors it finds during power-on
diagnostics and starts as it normally would. It’s a good idea to
keep this option enabled.
By disabling the System summary screen at boot
option, you can disable the system summary screen that you
see when you start the system. If you disable this option, your
system starts more quickly. You can see the same screen by
selecting the System Summary option from the SETUP Main
Menu. (See page 2-14).
Running SETUP and Installing Drivers 2-9