User`s guide

Position the connector on the cable so the red wire aligns

with pin 1 on the drive. Make sure the holes in the cable

connector fit over all the pins; then push in the connector.

power supply

cable

IDE device

cable

Locate one of the power supply cables that lead from the

power supply. (They have multi-colored wires and a plastic

connector on the end.) Align the notched comers of the

power supply connector and the drive’s power connector;

then push in the connector, as shown above.

Note

Your system includes five power supply cables; three

with full-size connectors and two with smaller

connectors. If you need more than these five connectors,

you can purchase Y-adapters for power supply cables at

most computer accessory stores. A Y-adapter allows you

to use one connector for two devices.

Installing and Removing Tower Drives

6-7