User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
Connecting the drive cable to the system board
Follow the steps below to connect the hard drive ribbon cable
to the system board, if it is not already connected.
1. Locate one of the hard disk drive ribbon cables that came
with your computer; it is a flat cable with a connector on
each end and an additional connector on the ribbon cable.
All the connectors on this cable look the same.
2. Locate the hard disk drive interface that you want to use on
the system board; see the illustration on page 4-6 to locate
the interfaces. Use the primary interface for your boot drive
and your second hard disk drive; use the secondary
interface if you are installing your third and fourth drives.
Installing and Removing Drives
5-9