User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
Removing the Cover
You need to remove the computer’s cover to install any of the
options described in this chapter or to install or remove a disk
drive (as described in Chapter 5). Follow these steps:
1. Turn off the computer and then any peripheral devices.
2. Disconnect the computer’s power cable from the electrical
outlet and from the back panel. Also disconnect any other
cables that are connected to the computer, including the
keyboard cable.
3. If the monitor is on top of the computer, lift it off and set it to
one side.
4. Turn the computer around so the back panel is facing you.
5. Remove the three screws securing the back panel, as shown
below.
4-2
Installing and Removing Options