User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
Chapter 4
InstaIling and Removing Options
You can enhance the performance of your computer by adding
optional equipment such as option cards, and system, video, or
cache memory modules.
This chapter first describes how to remove your computer’s
cover to install options and how to replace the cover when you
are finished. It then describes the following:
Locating the internal components
Changing the jumper settings
Installing and removing SIMMs (single inline memory
modules)
Instailing and removing option cards
Adding video memory
Instailing external cache.
Caution
Never install options or change jumper settings when the
computer is turned on or the power cable is connected to the
computer.
Once you have installed your options, see “Post-installation
Procedures" on page 4-22.
Installing and Removing Options
4-1