User`s guide

If resetting the computer does not correct the problem, you
probably need to turn it off and on again. Remove any
diskette(s) from the diskette drive(s). Turn off the computer
and wait 20 seconds. If your operating system is not on the
hard disk drive, insert a bootable diskette (one that contains the
necessary portions of the operating system) in drive A. Then
turn on the computer.
Using a Password
Using SETUP, you can define both a Supervisor level p as sword
and a User level password. You can also specify whether a
password is required when you start the system. This
password can also control who has access to the diskette drives.
If you enabled the Password on boot option in SETUP,
you must enter the Supervisor or User password every time
you turn on or reset the computer. If you enter a password but
disable the Password on boot option, you must enter the
password when you start SETUP.
If you set the Diskette access option to Supervisor, you
can access a diskette drive only if you entered the Supervisor
password when you started your system. If you entered a User
password when you started the system but the Diskette
access option is set to Supervisor, you see an error message
when you access the diskette drive.
When you need to enter your password, you’ll see the Security
Check window containing the prompt, Enter password:.
As you type your password, you see a rectangle for each
character you type. When you press Enter, the computer loads
the operating system (or starts SETUP).
3-10 Using Your Computer