User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
Entering or changing passwords
To specify a User password, you must first specify a Supervisor
password. Follow these steps to enter or change a password
1. Select Set Supervisor Password and press Enter.
2. You see a Set Supervisor Password window. Type a
password of up to seven characters and press Enter.
3. Type the same password a second time and press Enter.
see a message that your changes have been saved.
You
4. Press the spacebar. The Supervisor Password option
now displays Enabled.
To set a User password, select the Set user Password
option as you follow the steps above.
Deleting passwords
To delete your passwords, follow these steps:
1. Set the Password on boot option to Disabled.
2. Delete the User password by pressing Enter for both the
password field and the confirmation field. Don’t type any
characters in these fields.
3. Then delete the Supervisor password the same way.
Note
If you set both a User and Supervisor password, you must
delete the User password before you can access the
Supervisor password option.
If you forget your password, see “Password Problems” in
Chapter 6.
Running SETUP and Installing Drivers
2-11