User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
Setting the Voltage Selector Switch
Your system is powered by a 200 Watt power supply. The
power supply input voltage is controlled by a switch on the
computer’s back panel that may be set to 110 VAC or 220 VAC.
(The switch on your computer may read 115 VAC or 230 VAC;
these are equivalent settings.)
The computer is shipped with the voltage selector switch set to
110 VAC, which is appropriate for line source voltages between
100 and 120 VAC. This is generally the correct setting if you use
the computer in North America, South America, or Japan.
If you plan to operate the computer in the United Kingdom,
Europe, or some South American countries, you will almost
certainly need to reset the voltage selector switch to 220 VAC.
Line source voltages between 200 and 240 VAC are acceptable
with the switch set to 220 VAC.
Caution
Before you turn on the power to your system make sure the
voltage selector is set to the appropriate setting for the
electrical power source in your location or you will seriously
damage your system.
To change the voltage selector switch setting, slide the switch
to the left to select 110 VAC or to the right to select 220 VAC.
1-2 Setting Up Your System