User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
See the documentation that came with the option card to set
any necessary DIP switches or jumpers on the card. The
computer may also have some jumpers that must be set for the
option card to work properly. See Chapter 4 for system jumper
inform ation.
Make sure you install option cards that do not exceed the
system’s power supply limits; see Appendix A for more
inform ation.
Your system may need to operate at the slower processor speed
to access the device. Try reducing the processor speed, as
described in Chapter 3.
Make sure the option card is not touching any other card or
component on your main system board.
An external device connected to the option card is not
working correctly.
Make sure you are using the proper cable to securely connect
the device to the card.
Memory Module Problems
The memory count displayed by power-on diagnostics or
the SETUP program is incorrect.
You may have installed the SIMMs incorrectly. They may be
the wrong type or speed, or they may not be inserted all the
way or in the correct sockets. See Chapter 4 for information on
installing SIMMs.
If you have installed a gold-plated SIMM in the sockets, the
socket may have corroded slightly. Remove the SIMM and
clean the gold-plated connection with a pencil eraser; then
reinstall the SIMM.
Troubleshooting
6-13