User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
Diskette Drive Problems
A newly installed diskette drive is not working properly.
Make sure you have installed the drive correctly and check all
the cable connections.
You see a diskette drive error when you start your computer.
Run the SETUP program and configure your system for the
correct type of diskette drive. Also check the jumper setting of
JP4 to make sure the diskette drive controller is enabled.
The diskette drive is making loud or unusual noises
Contact your Authorized EPSON Servicer or the EPSON
Connection.
Hard Disk Drive Problems
A newly installed hard disk drive is not working properly or
its performance is not what you expect.
Make sure you have installed the drive correctly and check all
cable connections. Also, check the jumper settings on your
drive.
Check that you have installed the IDE driver on your hard disk
(see Chapter 2). To take advantage of the local bus IDE
interface, your hard disk drive must support a 32-bit data path
that uses double-word I/O. Also make sure your CONFIG.SYS
file is loading the IDE driver when you start your system.
Some hard disk drives do not support the Energy Star features
on your system. You may need to disable these features in
SETUP.
6-8
Troubleshooting