User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
Diskette Problems
You see a diskette error message.
Reinsert the diskette, making sure you insert it all the way. If
the drive has a latch, turn it down to secure the diskette.
Also, check to see that you have inserted the right type of
diskette in the drive. For example, make sure you are not
inserting a high-density diskette in a double-density drive.
If reinserting the diskette does not solve the problem, insert the
diskette in another diskette drive of the same type. If you can
read the diskette in a different drive, your drive may be faulty.
The diskette is the right type, but you still see an error.
Check that the diskette is not write-protected, preventing the
drive from writing to the diskette.
Make sure the diskette is formatted. See your operating system
documentation for instructions on formatting diskettes.
The system may have the Diskette access option in
SETUP enabled. If you entered a User level password when
you started the system, but this option is set to a Supervisor
level, you see an error when you access the drive.
You may have a defective diskette. Try copying the files from
the bad diskette to a new diskette.
Something is wrong with the data in the files
If you are using MS-DOS, run CHKDSK to repair the files. You
may also be able to use special utilities or diagnostics to solve
this problem.
Troubleshooting 6-7