User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING SETUP AND INSTALLING DRIVERS
- Using SETUP
- Starting the SETUP Program
- Using the System Setup Option
- Using the Fixed Disk Setup Option
- Using the Advanced System Setup Options
- Setting the Boot Options
- Using the Extended Features Options
- Setting the Security and Anti-Virus Options
- Using the Green PC Features
- Exiting SETUP
- Post-SETUP Procedures
- Installing the IDE Drivers
- Installing Video Drivers
- Using SETUP
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- CHAP 5-INSTALLING AND REMOVING DRIVERS
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Mouse Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Problems
- Software Problems
- Printer or Scanner Problems
- Option Card Problems
- Memory Module Problems
- Controller Problems
- External Cache Problems
- APPENDIX A SPECIFICATIONS
- CPU and Memory
- Controllers
- Interfaces
- Mass Storage
- Keyboard
- Mouse
- SETUP Program
- Power Supply
- Option Slot Power Limits
- Physical Characteristics
- Environmental Requirements
- Options Available from EPSON
- Tested Operating Environments
- System Memory Map
- Video Resolutions and Colors
- Hard Disk DriveTypes
- Drive Option Information
- DMA Assignments
- Hardware Interrupts
- System I/O Address Map
- Connector Pin Assignments
- GLOSSARY
- INDEX
Nothing happens when you type on the keyboard.
The Lockout Timer may be set in SETUP. This option
disables the keyboard for a specified period of time after the
system returns to an active mode from a low-power standby
mode. This delay gives Energy Star compliant monitors the
time they need to return to an active mode. Wait a few seconds
and try again.
If this is not the problem, see “The Computer Does Not
Respond,” above.
The cursor keys on the numeric keypad do not work
properly.
If the Num Lock light in the upper right corner of the keyboard
is lit, press
Num Lock to turn off the function.
Mouse Problems
Your mouse isn’t working properly or you see an a uxiliary
device error message.
Make sure the mouse cable is securely connected to the MOUSE
port and not the keyboard (K/B) port. Also make sure you
installed the mouse driver correctly (if necessary). See the
documentation that came with your mouse and Chapter 1 for
instructions. (Windows automatically installs a mouse driver
for Windows applications when you install the program.)
Monitor Problems
There is no display on the screen.
Check that the monitor’s power switch is on and that its power
light is on.
Troubleshooting 6-5