User`s guide

Changing the Jumper Settings
The jumpers on the system board are preset to factory default
positions, indicated by an asterisk (*) in the tables below. (See
the illustration on page 4-6 to locate jumpers.) Use the
information in this section to change jumper settings, if
necessary.
Note
Any jumpers not listed in the following tables are for service
purposes only. Do not change their settings.
Miscellaneous jumper settings
Jumper
number
JP28
VJP1
VJ3
Jumper
setting
1-2
2-3 *
1-2
2-3 *
1-2*
Open
Function
Clears CMOS memory (resets SETUP values to
factory defaults)
Normal CMOS values
Disables on-board VGA controller
Enables on-board VGA controller
Interlaced monitor type
Noninterlaced monitor type
* Default setting
Parallel port ECP mode DRQ jumper settings
Function JP30 JP31
DRQ1 (DAK#l)
1-2 1-2
DRQ3 (DAK#3) 2-3 * 2-3 *
* Default setting
Installing and Removing Options 4-7