User`s guide

MS-DOS version:
At the MS-DOS prompt, type VER
and press Enter.
Software versions:
In Windows applications, select
About from the Help menu. As
your software application starts, it
usually displays a version number
on the banner screen. Also, you can
check your software manual.
At the MS-DOS prompt, type
TYPE C: \CONFIG. SYS and press
Enter to see a listing of your
CONFIG.SYS file, which contains
system configuration commands.
CONFIG.SYS:
AUTOEXEC.BAT:
At the MS-DOS prompt, type
TYPE C:\AUTOEXEC. BAT and
press Enter to see a listing of your
AUTOEXEC.BAT file, which
contains system startup commands.
The Computer Will Not Start
The power light is on, but the computer does not start.
Place a bootable diskette in drive A and turn on the computer
again.
Caution
If you turn off the computer, always wait at least 20 seconds
before turning it back on to prevent damage to its circuitry.
If your computer is set to boot from drive C, make sure that the
IDE hard drive is formatted, and that the
OnBoard PCI IDE
option in SETUP is enabled.
Troubleshooting
6-3