Specifications

PARITY
The PARITY item specifies whether to use parity checking and
the type of parity checking to use. The parity bit, if used,
provides a basic form of error detection. The printer’s parity
setting must match the parity setting of your computer. See
your computer manual and software documentation for the
proper setting.
PARITY =
NONE (Default)
EVEN
ODD
STOP B/l
The STOP BIT item sets the number of stop bits on each
character of information sent to the printer. Stop bits signal the
end of a character. This setting must match the stop bit setting
of your computer.
STOP BITS= 1 (Default)
2
DTR
The DTR (Data Terminal Ready) item enables and disables the
printer’s ready communications protocol. Check your
computer manual for the setting you should be using. If
XON/XOPP is OFF, DTR must be set ON.
DTR=
OFF (Default)
ON
SelecType
4-23