Specifications

PARALLEL MENU
The PARALLEL MENU items allow you to adjust the speed
and bidirectional settings for the parallel interface.
SPEED
The SPEED item specifies transfer speed by specifying the
delay period from the STROBE to the ACKNLG signal.
Normally you do not need to change the SPEED item;
however, if your computer uses the ACKNLG signal, you
sometimes need to set SPEED to SLOW. For more information
on the parallel interface signal, see “Parallel interface” in
Appendix A.
SPEED=
FAST (Default)
SLOW
BI-D
The BI-D item enables or disables bidirectional communication.
If BI-D is set to OFF, LJ4 emulation will work as PCL 5
emulation. This means that some advanced features of LJ4
emulation will not be available.
BI-D= ON (Default)
OFF
SERIAL MENU
The items on the SERIAL MENU specify the settings for the
serial interface, including the type of serial interface (RS-232C
or RS-422) and the settings for word length, baud rate, parity,
stop bit, XON/XOFF, DTR, and DSR. If you are using the serial
interface, these settings must match your computer’s serial
settings.
SelecType 4-21