Specifications

Transparencies
You can use overhead projector transparencies and adhesive
drafting film if they are made for use with laser printers or
plain-paper copiers. When printing on these materials, print in
the faceup position.
Using manual feed
1.
Select the paper size and select manual feed as the paper
source.
If possible, use your software to select the paper source and
enter manual feed. Then skip to step 7.
If you are not able to select the paper source and manual
feed through your software, use the control panel buttons
as described in steps 2 through 6.
2.
Use the printer’s control panel to select the page size as
described in “Setting the paper tray’s paper size” earlier in
this chapter.
3.
To use the control panel buttons to select manual feed, first
hold down the Alt button and press the Manual button.
The display shows the following: MANUAL FEED=OFF.
4.
Press the arrow button once so the display now shows
MANUAL FEED = ON.
5.
Press the Enter button. An asterisk (*) indicates that the
setting shown is selected.
6.
Press the On Line button to put the printer back on line.
Note:
If the RESET TO SAVE message appears, press the Reset
button while you hold down the Alt button.
2-8 Paper Handling