Specifications

6. Insert the interface cable or cables into the U-shaped part of one cable
clip. Lift the left side of the printer up slightly. Then hook the short
lip of the clip into the forward slot and push the bottom of the clip
under the printer until it clicks in place. Repeat this procedure with
the second clip and insert it into the back slot.
7. Be SW the power is turned off; then plug the power cord into an
electrical outlet.
Checking the memory
Turn on the printer. You should see the following:
0 All indicator lights on the panel light briefly.
0 The ROM Check message appears.
0 The RAM Check message appears.
Make sure the printer displays the total amount of RAM that you now
have installed, including the 2.0 MB of standard memory.
If an incorrect amount appears, turn off the printer and remove the
controller board. Make sure you installed each SIMM in the correct
direction and that it is fully seated. If the RAM Check message is still
incorrect, contact your dealer or a qualified service person for assistance.
option Installation C-17