Specifications

If you are installing one SIMM, use the back slot. J.f you are installing two
SIMMs,usethebackslotforthefirstSIMM,and~~tslotfor~secand.
ToinstalltheSIMMs
1. Hold the SIMM as shown below and insert it into the slot at an angle
as shown below. Make sure the pin number of both the slot and the
slMMmatches,showing1 or 72.
2. Press the SIMM in firmly, in the direction shown in the illustration,
until it snaps into the notch of the connector. Do not apply too much
force.
3. Reinstall the controller board as shown in the next section.
C-14 option 1nstall!ation