Specifications

RESET
The printer’s current interface port has been reset and the
buffer cleared. However, other interface ports are still active
and retain their settings or data.
RESET ALL
All printer settings have been reset to the specified settings. For
information on specifying printer settings, see Chapter 4,
‘SelecType.”
RESET TO SAVE
You have changed a SelecType setting but the new setting has
not yet been enabled. To enable the new setting, hold down the
Alt button and press Reset.
SELF TEST
The printer is performing an internal check cycle. Please wait a
few seconds until the check is finished.
SERVICE REQ. XXXX
A controller error or a print engine error has been detected.
Write down the error number listed on the display and turn off
the printer. Wait at least five seconds and then turn it back on.
If the error message still appears, turn off the printer, unplug
the power cord, and contact a qualified service person.
Troubleshooting and h4aintenance 6-19