Specifications

74
9. After the printing, THICKNESS NUM is printed on the upper side
and the numeric data is printed on the lower side. Select the
noted number in step 8 using the Paper Feed (
u) or Paper
Feed (
d) button.
Note:
The default value depends on the PAPER THKNS. value in the
Head Alignment menu and is displayed as a THICKNESS NUM
in the Paper Configuration menu as shown below:
10. Press the Enter button to save the selected value.
11. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display CUT PRESSURE. Press the SelecType
button (
r) and Paper Feed ( u) or Paper Feed ( d) button to
set the cutter pressure for cutting paper, then the Enter button.
12. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display CUT METHOD. Press the SelecType button
(
r) and Paper Feed ( u) or Paper Feed ( d) button to select
either 3STEP or 4STEP, then the Enter button. When cutting
non-EPSON media and weaker or thicker paper, 4STEP is
recommended.
13. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display PPR FEED ADJ. Press the SelecType ( r)
button and Paper Feed (
u) or Paper Feed ( d) button to set
the paper feed amount, then the Enter button.
14. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display DRYING TIME. Press the SelecType ( r)
button and Paper Feed (
u) or Paper Feed ( d) button to set
the drying time in seconds, then the Enter button.
PAPER THKNS. value THICKNESS NUM
0.0 MM
to
1.6 MM
1
to
17