Specifications

73
1. Load the paper which you want to check referring “Using Roll
Paper” or “Using Cut Sheet Media”.
2. In the SelecType mode, press the Paper Feed (
u) or Paper
Feed (
d) button until PAPER CONFIG appears on the LCD
panel, and then press the SelecType button.
3. Press the Paper Feed (
u) or Paper Feed ( d) button to
display PAPER NUMBER appears on the upper row, and then
press the SelecType button.
4. Press the Paper Feed (
u) or Paper Feed ( d) button to select
the number you want to register as the setting, and then press
the Enter button. When you select STD, skip to step 8.
5. Press the Paper Source (
l), and press the Paper Feed ( u)
or Paper Feed (
d) button to display THICKNESS PAT.
6. Press the SelecType (
r) button, then PRINT appears.
7. Press the Enter button. The printer prints the paper thickness
test pattern.
Paper thickness test pattern example:
* smallest gap
8. Examine the printed pattern to determine which set of lines
are aligned (show the smallest gap), and note the
corresponding number.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
smallest gap