Specifications

254
4. Carefully pull down the jammed paper. TURN PWR OFF AND
ON is displayed on the LCD panel.
Note:
Do not touch the circuit board attached to the printer head when
handling the jammed paper.
5. Close the front cover, if necessary, then press the Power
button to turn the printer off and back on.
6. Make sure that the Paper Out light is on and LOAD PAPER is
displayed on the LCD panel. To load paper see “Using Roll
Paper” or “Using Cut Sheet Media”.
If you do not resume printing afterwards, make sure the print
heads are in the home (far right) position. If not, turn the printer
on, wait until the print heads move to the home position, then
turn off the printer.
c
Caution:
If the print heads are not left in the home position, print quality
may decline.
Troubleshooting on the Optional Auto
Take-up Reel Unit
Try one or more of these solutions:
❏ The roll paper may not have sufficient slack around the auto
take-up reel unit. Make sure that there is adequate slack
between the roll paper and the take-up reel core. See “Loading
roll paper onto the take-up reel core”.