Specifications

231

3. Send a print job to the printer. The printer starts printing. The

Auto Take-up Reel Unit takes-up the roll paper in the

direction you set in step 2.

Note:

Do not touch the

Manual

switch while printing is in progress.

Doing so may damage your prints.

Removing paper after take-up

After paper take-up, remove the take-up reel core as follows.

1. Turn off the Auto Take-up Reel Unit.

Warning:

Turn off the Auto Take-up Reel Unit before removing the

take-up reel core. If the take-up reel unit operates

unexpectedly, injury may occur.

2. Press the Paper Source button repeatedly on the printer until

the Roll Auto Cut light comes on.

Then press the Cut/Eject button. The roll paper is cut

automatically.

Note:

If you are printing on very thick roll paper, it is recommended that

you set the Auto Cut setting to off (at the printer’s control panel

and printer driver) and press the

Paper Feed

button on the printer

to feed the paper, then cut the paper yourself; otherwise the paper

cutter may be damaged. See “Cutting the roll paper manually”.